OBDHut

OBDHut

P2725

Moderate

Pressure Control Solenoid "E" Electrical

What Does P2725 Mean?

The TCM has detected an electrical fault in the pressure control solenoid E circuit, which could include open circuits, shorts, or abnormal resistance. This prevents the TCM from properly controlling hydraulic pressure through this solenoid.

Common Causes

35%

Failed pressure control solenoid E with open or shorted windings

Pressure Control Solenoid E

30%

Damaged wiring harness with broken wires or shorts

Transmission Wiring Harness

20%

Corroded or damaged solenoid connector

Solenoid Connector

10%

TCM internal circuit board failure

Transmission Control Module

5%

Transmission fluid intrusion into solenoid connector

Solenoid Connector Seal

Diagnostic Steps

1

Step 1: Measure resistance of solenoid E at connector; should be within manufacturer specs (typically 3-20 ohms)

2

Step 2: Check for voltage supply at solenoid connector with key on; verify TCM is providing ground signal

3

Step 3: Inspect connector for bent pins, corrosion, or fluid contamination; clean and repair as needed

4

Step 4: Perform continuity test on wiring from TCM to solenoid; check for shorts to ground or power

5

Step 5: If all wiring and solenoid test good, suspect TCM internal driver failure

Estimated Repair Cost

$200 - $1,200

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does P2725 mean?

The TCM has detected an electrical fault in the pressure control solenoid E circuit, which could include open circuits, shorts, or abnormal resistance. This prevents the TCM from properly controlling hydraulic pressure through this solenoid.

What causes P2725?

The most common cause of P2725 (Pressure Control Solenoid "E" Electrical) is: Failed pressure control solenoid E with open or shorted windings

How much does it cost to fix P2725?

Typical repair costs for P2725 range from $200 to $1,200, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with P2725?

May cause transmission to default to limp mode with limited gear availability. Can lead to unsafe passing situations or difficulty merging.

How do I diagnose P2725?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P2725 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Powertrain

System

Transmission Control System

Difficulty

Moderate

Type

Generic (SAE)

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.