OBDHut

OBDHut

P2167

Moderate

Throttle/Pedal Position Sensor "E" Maximum Stop Performance

What Does P2167 Mean?

The PCM has detected that throttle/pedal position sensor 'E' is not reaching its expected maximum voltage or position during calibration or operation. This indicates the sensor is unable to signal full throttle demand properly.

Common Causes

45%

Faulty accelerator pedal position sensor (APP sensor E circuit failure)

Accelerator Pedal Position Sensor
APP Sensor Assembly

30%

Wiring harness damage, corrosion, or connector issues in APP sensor E circuit

Wiring Harness
Electrical Connectors
Connector Pins

15%

PCM internal fault or calibration error

Powertrain Control Module

10%

Mechanical binding or obstruction in accelerator pedal assembly

Accelerator Pedal Assembly
Pedal Linkage

Diagnostic Steps

1

Step 1: Monitor live data for APP sensor E voltage throughout pedal travel range (idle to wide-open throttle)

2

Step 2: Inspect accelerator pedal assembly for mechanical binding, restricted movement, or physical damage

3

Step 3: Check wiring harness and connectors for APP sensor E circuit for corrosion, damaged pins, or broken wires

4

Step 4: Test APP sensor E voltage supply and ground circuits with DVOM, verify reference voltage (typically 5V)

5

Step 5: Perform APP sensor relearn/calibration procedure if available, replace sensor if voltage range is incorrect

Estimated Repair Cost

$150 - $600

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does P2167 mean?

The PCM has detected that throttle/pedal position sensor 'E' is not reaching its expected maximum voltage or position during calibration or operation. This indicates the sensor is unable to signal full throttle demand properly.

What causes P2167?

The most common cause of P2167 (Throttle/Pedal Position Sensor "E" Maximum Stop Performance) is: Faulty accelerator pedal position sensor (APP sensor E circuit failure)

How much does it cost to fix P2167?

Typical repair costs for P2167 range from $150 to $600, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with P2167?

Reduced throttle response or limp mode activation may limit vehicle acceleration and performance. Vehicle may enter reduced power mode affecting ability to merge or pass safely.

How do I diagnose P2167?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P2167 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Powertrain

System

Electronic Throttle Control System

Difficulty

Moderate

Type

Generic (SAE)

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.