OBDHut

OBDHut

U1071

Professional

SCP (J1850) Invalid or Missing Data for Engine Sensors

What Does U1071 Mean?

Similar to U1070, this code indicates invalid or missing engine sensor data on the SCP network. This may represent a different receiving module or specific sensor parameter set that is not being transmitted properly.

Common Causes

30%

PCM communication failure or internal fault

PCM
ECM

25%

Intermittent connection at SCP network terminals

Wiring Connectors
PCM Connector

20%

SCP bus circuit short to ground or power

Communication Wiring
Harness

15%

Failed engine sensors causing PCM to not broadcast valid data

MAF Sensor
MAP Sensor
TPS

10%

Network termination resistor failure

Network Resistor
BCM

Diagnostic Steps

1

Step 1: Compare fault occurrence with U1070 to determine if same or different receiving module

2

Step 2: Monitor live data stream from PCM for all engine sensor parameters

3

Step 3: Wiggle test SCP bus wiring and connectors while monitoring for communication loss

4

Step 4: Check for other engine sensor DTCs that may prevent PCM from broadcasting data

5

Step 5: Measure SCP bus termination resistance (should be approximately 60-120 ohms)

Estimated Repair Cost

$150 - $1,400

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does U1071 mean?

Similar to U1070, this code indicates invalid or missing engine sensor data on the SCP network. This may represent a different receiving module or specific sensor parameter set that is not being transmitted properly.

What causes U1071?

The most common cause of U1071 (SCP (J1850) Invalid or Missing Data for Engine Sensors) is: PCM communication failure or internal fault

How much does it cost to fix U1071?

Typical repair costs for U1071 range from $150 to $1,400, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with U1071?

May cause erratic gauge operation and loss of critical engine information display. Engine performance may be affected if running in failsafe mode.

How do I diagnose U1071?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to U1071 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Network

System

Engine Management / Communication Network

Difficulty

Professional

Type

Manufacturer

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.