OBDHut

OBDHut

P3467

Moderate

Cylinder 9 Deactivation/Intake Valve Control Circuit Low

What Does P3467 Mean?

The PCM has detected voltage in the cylinder 9 intake valve control circuit that is lower than expected specifications. This indicates insufficient voltage reaching the solenoid, preventing proper valve control operation.

Common Causes

35%

High resistance in ground circuit for intake valve control solenoid

Ground wire
Ground connection
Engine ground strap

30%

High resistance in power supply circuit due to corrosion or damage

Wiring harness
Electrical connectors
Fuse

20%

Partially shorted intake valve control solenoid drawing excessive current

Intake valve control solenoid

10%

Corroded or loose connector terminals creating voltage drop

Electrical connector
Terminal pins

5%

Weak PCM driver circuit unable to supply adequate voltage

Powertrain Control Module

Diagnostic Steps

1

Step 1: Measure voltage at intake valve control solenoid connector while PCM commands activation; should show battery voltage

2

Step 2: Perform voltage drop test on ground circuit from solenoid to battery negative; should be less than 0.1V

3

Step 3: Check power supply circuit from PCM to solenoid for voltage drop; should be less than 0.2V under load

4

Step 4: Measure solenoid resistance and compare to specifications; out-of-range indicates solenoid fault

5

Step 5: Inspect all connector terminals for corrosion, looseness, or signs of overheating; clean and repair as needed

Estimated Repair Cost

$100 - $700

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does P3467 mean?

The PCM has detected voltage in the cylinder 9 intake valve control circuit that is lower than expected specifications. This indicates insufficient voltage reaching the solenoid, preventing proper valve control operation.

What causes P3467?

The most common cause of P3467 (Cylinder 9 Deactivation/Intake Valve Control Circuit Low) is: High resistance in ground circuit for intake valve control solenoid

How much does it cost to fix P3467?

Typical repair costs for P3467 range from $100 to $700, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with P3467?

Cylinder 9 intake valve control may be inoperative, causing performance loss and reduced fuel economy. Safe to drive short distances but repair soon to prevent potential engine damage or catalytic converter failure.

How do I diagnose P3467?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P3467 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Powertrain

System

Variable Valve Timing/Cylinder Deactivation System

Difficulty

Moderate

Type

Generic (SAE)

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.