OBDHut

OBDHut

P2745

Moderate

Intermediate Shaft Speed Sensor B Circuit

What Does P2745 Mean?

The transmission control module has detected a fault in the intermediate shaft speed sensor B circuit. This sensor monitors the rotational speed of an intermediate shaft within the transmission to enable proper shift timing and clutch control.

Common Causes

35%

Intermediate shaft speed sensor B failure or internal short/open circuit

Intermediate Shaft Speed Sensor B

25%

Damaged wiring harness or connector pins at sensor B

Wiring Harness
Sensor Connector

20%

Metal contamination on sensor tip affecting magnetic pickup

Intermediate Shaft Speed Sensor B

15%

Damaged or missing reluctor ring/tone wheel on intermediate shaft

Reluctor Ring
Tone Wheel

5%

Transmission control module (TCM) circuit failure

Transmission Control Module

Diagnostic Steps

1

Step 1: Inspect sensor connector for damage, corrosion, or oil contamination that could affect signal

2

Step 2: Measure sensor resistance and compare to specifications (typically 200-1000 ohms for passive sensors)

3

Step 3: Check sensor air gap between sensor tip and reluctor ring if accessible without disassembly

4

Step 4: Remove sensor and inspect tip for metal debris, damage, or excessive wear; clean and reinstall

5

Step 5: Monitor sensor signal with oscilloscope during operation if possible, or verify signal wire continuity to TCM

Estimated Repair Cost

$200 - $600

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does P2745 mean?

The transmission control module has detected a fault in the intermediate shaft speed sensor B circuit. This sensor monitors the rotational speed of an intermediate shaft within the transmission to enable proper shift timing and clutch control.

What causes P2745?

The most common cause of P2745 (Intermediate Shaft Speed Sensor B Circuit) is: Intermediate shaft speed sensor B failure or internal short/open circuit

How much does it cost to fix P2745?

Typical repair costs for P2745 range from $200 to $600, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with P2745?

Transmission may experience harsh or delayed shifts, incorrect gear selection, or enter limp mode limiting vehicle to one or two gears. Drive cautiously and avoid aggressive acceleration.

How do I diagnose P2745?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P2745 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Powertrain

System

Transmission Control System

Difficulty

Moderate

Type

Generic (SAE)

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.