OBDHut

OBDHut

P2600

Moderate

Coolant Pump "A" Control Circuit/Open

What Does P2600 Mean?

The PCM has detected an open circuit or control failure in the electric coolant pump A control circuit. Modern vehicles may use electric auxiliary coolant pumps for enhanced cooling, and this code indicates the pump is not receiving proper electrical signals.

Common Causes

35%

Open circuit in coolant pump wiring harness or broken wire

Wiring Harness
Coolant Pump Connector

30%

Failed electric coolant pump with open motor windings

Electric Coolant Pump

20%

Blown fuse or faulty relay in coolant pump power circuit

Coolant Pump Fuse
Coolant Pump Relay

10%

Corroded or disconnected coolant pump connector

Coolant Pump Connector
Connector Terminals

5%

PCM coolant pump driver circuit failure

Powertrain Control Module

Diagnostic Steps

1

Step 1: Check coolant pump fuse and relay operation - test relay with multimeter and swap with known good relay if available

2

Step 2: Disconnect coolant pump connector and measure voltage at pump supply terminal with pump commanded on - should see battery voltage

3

Step 3: Test coolant pump motor resistance using multimeter - compare to specifications (typically 0.5-5 ohms)

4

Step 4: Check ground circuit continuity and perform voltage drop test on ground side while pump is commanded on

5

Step 5: Apply direct power to coolant pump to verify motor operation independent of control circuit

Estimated Repair Cost

$200 - $800

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does P2600 mean?

The PCM has detected an open circuit or control failure in the electric coolant pump A control circuit. Modern vehicles may use electric auxiliary coolant pumps for enhanced cooling, and this code indicates the pump is not receiving proper electrical signals.

What causes P2600?

The most common cause of P2600 (Coolant Pump "A" Control Circuit/Open) is: Open circuit in coolant pump wiring harness or broken wire

How much does it cost to fix P2600?

Typical repair costs for P2600 range from $200 to $800, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with P2600?

Risk of engine overheating, especially during idle or low-speed operation. Monitor temperature gauge closely and avoid extended idling until repaired.

How do I diagnose P2600?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P2600 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Powertrain

System

Engine Cooling System

Difficulty

Moderate

Type

Generic (SAE)

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.