What Does P0A19 Mean?
DTC P0A19 indicates the motor torque sensor circuit is reporting a voltage below the minimum threshold expected by the hybrid control module. This low-signal condition typically points to a sensor shorted to ground, a failed sensor element, or grounded wiring. Without valid torque feedback, the control module may limit motor output or disable electric drive mode entirely.
Safety Warning
A perpetually low torque reading may cause the control module to either severely limit motor output or attempt to compensate by increasing torque, both of which can create unpredictable driving behavior. Loss of regenerative braking feedback is particularly hazardous.
Common Causes
30%
Short to ground in the motor torque sensor signal wiring
30%
Internally failed torque sensor with a grounded or shorted output element
20%
Moisture intrusion or coolant contamination at the sensor connector creating a ground path
15%
Damaged signal wire insulation making contact with the motor housing or vehicle chassis
5%
Hybrid control module sensor input fault
Diagnostic Steps
1
Read live data to confirm the torque sensor signal voltage is at or near zero, consistent with a low-circuit condition.
2
Disconnect the torque sensor and check if the scan tool reading changes to a reference voltage level; this confirms the sensor was pulling the signal low.
3
With the sensor disconnected, check the signal wire for continuity to ground to locate a harness short.
4
Inspect the sensor connector and surrounding area for coolant leaks, moisture, or contamination that could provide a ground path; the motor area can be exposed to cooling system fluids.
5
Replace the torque sensor if it is confirmed as the source of the low signal; clear codes and verify proper signal range during a test drive.
Estimated Repair Cost
$400 - $1,800
Parts + labor, varies by vehicle and location
DTC P0A19 indicates the motor torque sensor circuit is reporting a voltage below the minimum threshold expected by the hybrid control module. This low-signal condition typically points to a sensor shorted to ground, a failed sensor element, or grounded wiring. Without valid torque feedback, the cont...
The most common cause of P0A19 (Motor Torque Sensor Circuit Low) is: Short to ground in the motor torque sensor signal wiring
Typical repair costs for P0A19 range from $400 to $1,800, depending on the vehicle, location, and whether you do it yourself or go to a shop.
A perpetually low torque reading may cause the control module to either severely limit motor output or attempt to compensate by increasing torque, both of which can create unpredictable driving behavior. Loss of regenerative braking feedback is particularly hazardous.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P0A19 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Powertrain
System
Hybrid/EV Powertrain
Difficulty
Type
Generic (SAE)
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
