What Does P0311 Mean?
The ECM has detected a misfire condition specifically in cylinder 11. This code applies to V12 and W12 engines found in luxury and high-performance vehicles. The crankshaft position sensor detects a deceleration during the cylinder 11 power stroke. The driver may notice rough running, vibration, reduced power, and the check engine light. Due to the complexity of 12-cylinder engines, access to cylinder 11 components can be challenging.
Safety Warning
A misfiring cylinder sends unburned fuel to the catalytic converter, causing overheating and potential failure. If the check engine light is flashing, minimize driving and avoid high load. V12 repairs are typically expensive — address promptly to prevent cascade damage to catalytic converters.
Common Causes
30%
Worn or fouled spark plug on cylinder 11 unable to produce adequate spark
25%
Failing ignition coil on cylinder 11 producing weak or intermittent spark
20%
Fuel injector on cylinder 11 restricted or malfunctioning
15%
Compression loss on cylinder 11 from worn rings, leaking valve, or head gasket failure
10%
Wiring harness damage to cylinder 11 coil or injector in the tightly packaged V12/W12 engine bay
Diagnostic Steps
1
Swap the ignition coil from cylinder 11 with an adjacent cylinder — if the misfire follows the coil, replace it; if it stays on cylinder 11, the coil is not the cause.
2
Remove and inspect the cylinder 11 spark plug — check gap, electrode condition, and fouling pattern; on V12/W12 engines this may require significant disassembly for access.
3
Check cylinder 11 fuel injector with a stethoscope or Noid light — verify it clicks rhythmically at idle; measure resistance (typically 11-18 ohms) and compare to other cylinders.
4
Perform a compression test on cylinder 11 — minimum is typically 100 PSI and should be within 10% of the highest cylinder; low compression requires a leak-down test.
5
Review cylinder 11 individual fuel trim data — if the ECM shows high positive correction, suspect a restricted injector; high negative correction suggests a leaking injector.
Estimated Repair Cost
$150 - $1,500
Parts + labor, varies by vehicle and location
The ECM has detected a misfire condition specifically in cylinder 11. This code applies to V12 and W12 engines found in luxury and high-performance vehicles. The crankshaft position sensor detects a deceleration during the cylinder 11 power stroke. The driver may notice rough running, vibration, red...
The most common cause of P0311 (Cylinder 11 Misfire Detected) is: Worn or fouled spark plug on cylinder 11 unable to produce adequate spark
Typical repair costs for P0311 range from $150 to $1,500, depending on the vehicle, location, and whether you do it yourself or go to a shop.
A misfiring cylinder sends unburned fuel to the catalytic converter, causing overheating and potential failure. If the check engine light is flashing, minimize driving and avoid high load. V12 repairs are typically expensive — address promptly to prevent cascade damage to catalytic converters.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P0311 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Powertrain
System
Ignition System
Difficulty
Type
Generic (SAE)
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
