What Does C0584 Mean?
This code indicates that the ABS/Stability Control module has detected an open circuit in the right front wheel's ABS/brake pressure control solenoid valve circuit. The module is unable to complete the electrical pathway to energize the solenoid, which means it cannot properly modulate brake pressure during ABS or stability control events. This fault was detected during system self-diagnostics or during an attempted activation of the solenoid valve.
Common Causes
40%
Broken or corroded wiring between ABS module and right front solenoid valve, often due to water intrusion or physical damage
30%
Failed ABS hydraulic control unit with internal solenoid valve failure or open coil windings
20%
Corroded or loose connector at the ABS hydraulic control unit or wheel speed sensor harness junction
10%
Failed ABS control module with internal driver circuit failure for the right front solenoid
Diagnostic Steps
1
Perform visual inspection of the right front wheel area and ABS hydraulic unit for damaged wiring, corroded connectors, or signs of water intrusion; check all connectors for proper seating and terminal corrosion
2
Using a digital multimeter, measure resistance across the right front solenoid valve terminals at the ABS hydraulic unit connector (disconnected); typical solenoid resistance should be 2-8 ohms depending on vehicle manufacturer
3
Check for continuity between the ABS control module connector and the hydraulic unit solenoid connector using a multimeter; verify no open circuits or excessive resistance (should be less than 1 ohm) in the wiring harness
4
Inspect the ABS module connector for pushed-back pins, corrosion, or damaged terminals; clean and repair as necessary, then verify proper pin tension and connection integrity
5
If wiring and connections test good, perform a voltage supply test at the solenoid circuit with ignition on to verify the ABS module is providing switching voltage (typically 12V); if no voltage is present with good wiring, the ABS module internal driver may be faulty
6
Clear codes and perform a test drive with multiple ABS activation events on safe surface; monitor for code return and verify proper ABS function using scan tool live data for solenoid activation
Estimated Repair Cost
$150 - $1,200
Parts + labor, varies by vehicle and location
This code indicates that the ABS/Stability Control module has detected an open circuit in the right front wheel's ABS/brake pressure control solenoid valve circuit. The module is unable to complete the electrical pathway to energize the solenoid, which means it cannot properly modulate brake pressur...
The most common cause of C0584 (Right Front Solenoid Circuit Open) is: Broken or corroded wiring between ABS module and right front solenoid valve, often due to water intrusion or physical damage
Typical repair costs for C0584 range from $150 to $1,200, depending on the vehicle, location, and whether you do it yourself or go to a shop.
Vehicle is safe to drive under normal braking conditions, but ABS and stability control functions will be disabled or degraded on the right front wheel, which may result in wheel lockup during hard braking or loss of traction control on slippery surfaces. Repair should be completed promptly to restore full braking safety systems.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to C0584 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Chassis
System
Anti-lock Braking System (ABS) / Electronic Stability Control
Difficulty
Type
Generic (SAE)
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
