What Does B1529 Mean?
B1529 indicates the Body Control Module (BCM) has detected a fault in the Driver Information Center (DIC) switch circuit. This code means there is an open circuit, short to ground, short to voltage, or excessive resistance in the wiring or switch that controls the DIC buttons used to navigate vehicle information displays. The BCM monitors the switch inputs and sets this code when the circuit voltage or resistance falls outside expected parameters.
Common Causes
45%
Faulty DIC switch assembly with worn contacts, stuck buttons, or internal circuit board failure
30%
Damaged or corroded wiring harness between BCM and DIC switch, including chafed insulation or broken wires
15%
Corroded or loose electrical connector at the DIC switch or BCM with poor terminal contact
10%
Body Control Module internal circuit fault or software issue
Diagnostic Steps
1
Step 1: Perform visual inspection of the DIC switch assembly for physical damage, stuck buttons, or signs of liquid intrusion. Operate each button and check for proper tactile feedback and function.
2
Step 2: Disconnect the DIC switch connector and inspect for corrosion, pushed-back pins, or moisture. Clean contacts with electrical contact cleaner if corrosion is present. Measure resistance across switch terminals while pressing each button (typical resistance values should be specific stepped resistances, usually 0-2000 ohms depending on button).
3
Step 3: Using a digital multimeter, backprobe the DIC switch connector at the harness side with key on, engine off. Verify reference voltage from BCM (typically 5V or 12V) is present on the supply wire. Check for proper ground continuity (less than 1 ohm to chassis ground).
4
Step 4: Perform continuity test on the signal wire(s) between the DIC switch connector and BCM connector with harness disconnected at both ends. Check for shorts to ground or voltage by measuring resistance to ground and power (should be infinite/open circuit).
5
Step 5: If wiring and connections test good, substitute a known-good DIC switch assembly to confirm if the switch is faulty. Clear codes and test operation through all button functions.
6
Step 6: If all previous tests pass, suspect BCM fault. Verify BCM software is up to date and consider BCM replacement or reprogramming if all other components test within specification.
Estimated Repair Cost
$100 - $450
Parts + labor, varies by vehicle and location
B1529 indicates the Body Control Module (BCM) has detected a fault in the Driver Information Center (DIC) switch circuit. This code means there is an open circuit, short to ground, short to voltage, or excessive resistance in the wiring or switch that controls the DIC buttons used to navigate vehicl...
The most common cause of B1529 (Driver Information Center (DIC) Switch Circuit) is: Faulty DIC switch assembly with worn contacts, stuck buttons, or internal circuit board failure
Typical repair costs for B1529 range from $100 to $450, depending on the vehicle, location, and whether you do it yourself or go to a shop.
This code does not affect vehicle safety or drivability. The vehicle is safe to drive, though you may lose the ability to view or reset certain information displays like trip computer, fuel economy, or maintenance reminders. Repair can be scheduled at convenience.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to B1529 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Body
System
Body Control and Driver Interface
Difficulty
Type
Manufacturer
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
